Technical Specifications

Clinch Nuts Type NS

Thread & Pitch	Material Code	C Max	D +/- 0.2	H +/- 0.1	S MAX	Min. Rec. Sheet tdickness	Hole Size +0.08 -0.00	Min. Dis. to Edge of Sheet	Torque Out	Push Out
M3x0.5	0 1 2	4.22	6.3	1.5	0.76 0.97 1.37	0.8 1.0 1.4	4.25	4.8	2.01 Nm 2.12 Nm 2.34 Nm	489 N 572 N 1106 N
Alt M3x0.5	0 1 2	4.73	7.1	1.5	0.76 0.97 1.37	0.8 1.0 1.4	4.75	5.6	1.9 Nm 2.5 Nm 2.9 Nm	501 N 594 N 1224 N
M3.5x0.6	0 1 2	4.73	7.1	1.5	0.76 0.97 1.37	0.8 1.0 1.4	4.75	5.6	1.8 Nm 2.4 Nm 3.0 Nm	457 N 602 N 1189 N
M4x0.7	0 1 2	5.38	7.9	2.0	0.76 0.97 1.37	0.8 1.0 1.4	5.4	6.9	3.1 Nm 4.2 Nm 5.0 Nm	506 N 689 N 1293 N
M5x0.8	0 1 2	6.38	8.7	2.0	0.76 0.97 1.37	0.8 1.0 1.4	6.4	7.1	3.8 Nm 4.5 Nm 6.9 Nm	564 N 871 N 1487 N
M6x1.0	0 1	8.72	11.05	4.1	1.37 2.21	1.4 2.3	8.75	8.6	17.8 Nm 17.9 Nm	1842 N 1838 N

Materials		Standard finishes
Carbon Steel		Bright Zinc / Clear passivated to BS 3382 (ZI)
303 Stainless Steel (A2)		(Zinc/Yellow Passivated (ZC) Available to Special Order)

Notes

Steel parts are suitable for use in sheets with a maximum hardness of 80 HRB.

Stainless Steel Parts are suitable for use in sheets with a maximum hardness of 70 HRB.

(Stainless Steel parts will not usually install successfully in Stainless Sheet). If you need to install into stainless sheet please contact our sales department for alternatives. Aluminium parts are suitable for installation in sheets witd a maximum hardness of 50 HRB.